XT60 5.3V DC BEC Power Module - APM and Pixhawk

XT60 5.3V DC BEC Power Module - APM and Pixhawk

The APM 2.5 Power Module is a simple way to provide your APM 2.5 with clean power from a LiPo battery as well as current consumption and battery voltage measurements with a 6-pos cable. The built-in switching regulator provides 5.3V and maximum 2.25A output for up to 4S LiPo battery. The Power Module comes fully assembled with Deans connectors and wrapped in shrink tubing for protection.


XT60 5.3V DC BEC Power Module - APM and Pixhawk Specifications:

• Max input voltage: 30V
  • Max current detection: 90A
  • Configured voltage and current measurement for 5V ADC
  • Switching regulator outputs 5.3 V and 3A max
  • 6P molex cable plugs directly into 'PM' connector of APM / Arduflyer 2.5
  Size:137mm
  • Cable length: 192 mm
  • Net Weight: 27g

Similar products:

• APM2.8 ArduPilot Mega2.8 Flight Control Board
• SE100 M8N GPS for Radiolink MINI PIXHAWK - With Mount
• Radiolink R12DS 2.4G AT9 AT9S 12 Channel DSSS FHSS Receiver for Controller
• Emlid Navio 2 Flight Control Board